VO-BB - 20 YEARS OLD!

Eddie Eagle · M&M Joined: 23 Apr 2008 Posts: 2393

Been a while since I used SC Standard 3.7
Getting the Port Unavailable
Tried an echotest 48k mono and it takes a while but I get a send and receive.

Port forwarding for Source Connect is set up on my router. Maybe some data has changed that I need to update in the port forward settings?

Any suggestions or snide remarks welcome.

Mike Harrison · Posted: Sun Dec 10, 2017 10:55 am Post subject:

Eddie, this always send me over the edge, too, so I made notes and took screen shots last time.

In your router settings for Source-Connect, make sure ports 6000-6002 are selected. Also make sure the ip address there matches the ip address in your computer's Network settings.

See if that helps.
_________________
Mike
Male Voice Over Talent
I have taken leave of my sensors.

Eddie Eagle · M&M Joined: 23 Apr 2008 Posts: 2393

still says unavailable.
According to their support it should be 6000 and 6001
Shocked

Mike Harrison · Posted: Sun Dec 10, 2017 11:18 am Post subject:

I don't know if this will affect it, but do your firewall settings allow Source-Connect?
_________________
Mike
Male Voice Over Talent
I have taken leave of my sensors.

Eddie Eagle · M&M Joined: 23 Apr 2008 Posts: 2393

Thanks I tried that it doesn't seem to interfere. I'm going to set up a source element support session tomorrow appreciate it

Eddie Eagle · M&M Joined: 23 Apr 2008 Posts: 2393

Some kind of installer was blocking SC. Took us a while to figure it out.
Safenet installer was the blocker.

Works fine again.